LG51LG61.061（1.5）ーーVP.0GGﾟ51●Process a 15° relief chamfering on the mounting surface along the extension line of shank to●Reduce flange R.●Add a pressーin lead（V,H－0.01 ●Alter the screw hole diameter.●Alter the ejector spring to reinforced type.●Lap tip effective part. Shape Alteration Others－0.03）1.61.6208Relief chamfering additionFlange R alterationPress-in lead additionFlanged typeScrew hole diameter alterationEjector pin material alteration （SUS）JSC（100）●Alter the material of ejector pin to SUS304（non-magnetic）.Vent cancellingEjector pin sets cancellingTip effective part lappingR0.8～1.0→R≦0.3Straight typeV,H－0.01－0.03Shoulder Held TypeV,H－0.01－0.03V,H－0.01－0.03SUS304Spring rigidity alteration MC free size typeH dimensionMMC（selective）43 6.1～ 8.054,6 8.1～10.064（V10.1～16.0）,5,810.1～13.084（V13.1～20.0）,6,1013.1～16.086,1016.1～30.0 （ ）are SKD11 only. MC straight type5.01～20.00W 5.01～ 6.00M4→M3 6.01～ 8.00M5→M4 8.01～10.00M6→M510.01～13.00M8→M6BlanksShoulder Held TypeGeneral typeV,H－0.01－0.03Tapped typeV,H－0.01－0.03Add.Add.Code@/PFK（Single-flange 200）（Double-flange 400）flange, in order to prevent breakage caused by stress concentration.Process one relief chamfering for single-flange type, two for double-flange type.Combined with HC is available.RE（300）Flange thickness 10mm type is available.DC（200）For blanks, flanged type is not available.MCMMC（0）（Free size type 200）Tapped type is available only（except for ejector type）. MCSKD11VH 6 8ー10ー13ー MMCSKD11681013162022H10ーM6→M4ー13ーM8→M56810131620222528・30M4→M3M5→M4M6→M5M8→M6To prevent more dross attached on ejector pin part, which is caused by the friction during. processing, SUS 304（non-magnetic）is applied.Combined with JLC （ejector pin length alteration） is available.The hardness of ejector pin is under 200HV（less≒12HRC）.Please pay attention when material hardness is lower than standard ejector pin（SKD61, hardness 40HRC～）.SHC（0）Spring constant：0.49N／mm（0.05kgf／mm）→0.98N／mm（0.1kgf／mm）H≧8 is available.AC（－100）●Use centre hole as vent by removing ejector pin sets, cancel the side hole.Express is not available.NC（－200）●Cancel ejector pin sets.Combined with AC is not available.Code@/PSC（Round 800）（Special shaped 1,200）For straight type, the range of lapping refers to right drawing.Delivery＝standard delivery＋2 daysFor tip shape D, R＝0 is not available.Spec.SKH51・SKH40VH 6 8ー10ー13ー681013162022ーM4→M3M5→M4M6→M5M8→M6Spec.Guide for Block Punches Addition
元のページ ../index.html#210