0≦BC≦2（quill type）1≦BC≦4（bolt fixed type）K（angle of blanking hole） AN（standard dimension of blanking hole）ANC（designated dimension of blanking hole）CBCLCLBLLT1P1BLWBPCT●Alter the shaped hole“B”dimension.Range of designation0≦BC≦4●Reduce the flange width.Range of designation0≦HC＜1.5Unit of designation●Reduce the flange thickness“T”dimension.Range of designation2≦TC＜5Unit of designation Drawing 3 Drawing 2P・W●Shaped hole （P・W dimensions） are unchanged, but shank （V・H dimensions） are circumrotated 90°.WVWHVPHPCode@/PBC（200）Unit of designation 0.1Scrap retentionRange of designation1≦BC≦4●Reduce the overall length“L”dimension.Range of designation10≦LC＜LLC（200）16＜LC＜35（bolt fixed type）Unit of designation 0.1→Combined with LKC・LKP can be For single-flange type, LC≦12, no press-in lead.HC（200） 0.1TC（200） 0.1→Combined with TKC・TKCM can be L is shortened according to（5−TC）.When LC is applied, L is equal to LC.Code@/PANC（200）●Alter the blanking hole of angular button dies according to designated dimension.Range of designationAN＜ANC≦P＋4≦Pmax （AN＝P＋（L−B）／50） K（Angle of blanking hole）≦5 （K=tan−1｛（ANC−P）／2（L−B）｝） Drawing 1 B≦（P−0.6）／tanK （round type） Drawing 2 B≦（W−0.6）／tanK （special shaped type） Drawing 2 0.1Unit of designationAlter AN to ANC within the range of PCmax by （1／50） taper increment.Angle（K）of blanking hole is 5°max.The distance between shaped hole length B and wire is 0.6mm min. For special shaped hole, entire processing was applied according to the blanking hole angle K calculated from P dimension and ANC dimension. For shaped hole on centre of shank only.Drawing 1Designated X・Y are not available.HVC（0）The processing range of P dimension is W dimension in standard dimension table.Available when shaped hole and shank are coaxial.Special shaped type is available.Designated X・Y are not available.NNHC（−100）●Cancel the starting hole.SRC（800）●Add slanted grooves（N）.Range of designation4≦N≦6Processing position 360°／NFor round type, P≧4.00 is available.For N＝4, refer to left drawing.422B dimension alterationL dimension alterationFlange width alterationT dimension alterationBlanking hole dimension alterationShank 90°circumrotationStarting hole cancellingSlanted grooves additionHC1.550ANC120°90°50Drawing 2 0.01. Drawing 10.6mm or moreShaped holeWireDrawing 3Add. For details, refer to the specific page please.Add.Spec. 0.01.Spec. Dimension Alteration Shape AlterationGuide for Block Dies Addition
元のページ ../index.html#424