PRESS2010_EN

539/1208

52−6PTSMM52−6SMMK≦2（SKF−0.1）W・K maxW≦2（SKF−0.1）4〜253D／10D／2ー0.14〜 6D／2−0.5D／2ー0.18〜D／2−1.0D／2ー0.1 0.1seD nottuB&sehcnuP depahSCLJ lacepS22・2.52・2.5・3H＞5：0.5≦CTC≦1.5K≦D−1.2K≦D−2.2W・K maxW≦D−1.2W≦D−2.2D4〜6D／2−0.58〜D／2−1.0ー0.01ー0.01Add.Add.Code@/PJLC（200）●Alter the projection length of ejector pin.Ejector punchesJLC 4〜6Not available 8101316〜2・2.5・3・3.5・4Due to the probability of extended projection being broken, pay attention during selection please.Combined with JSC（Ejector pin material（SUS）alteration） is available.D≦32 is available.Code@/PCTC（200）●Chamfer on the head.Range of designationH≦5：CTC＝0.5Unit of designation 0.1For punches・ejector punches, standard・centre hole types are available.SKC（600）●Add a stop flat on the shank.SKCStandard type・tapped type・ejector type are available.For tapped type, D5 is not available.Combined with KC・WKC・WKD・CKC・WKF・SKF are not available.2L・3L are not available.SKF（800）●Add a designated stop flat on the shank.Range of designationTypePunchesTapped typeEjector typeUnit of designationStandard type・tapped type・ejector type are available.For tapped type, D5 is not available.Combined with KC・WKC・WKD・CKC・WKF・SKC are not available.2L・3L are not available.AC（−100）●Use centre hole as vent by removing ejector pin sets, cancel the side hole.Combined with NC is not available.NC（−200）●Cancel ejector pin sets.Combined with AC is not available.KNC（100）●Alter the straight dowel pin to tapped precision type.Alter MMS6−25→MMSTP6−25.Spec.Ejector heavy load punchesStandardStandard1JLCDD4ii D 8・10Not available13〜204.5・5・5.54.5・5・5.5・61.525Spec.Except for 8H・12H・17J・18J8H・12H・17J・18JSKFminmaxExcept for 8H・12H・17J・18J8H・12H・17J・18J Dimension Alteration Shape AlterationEjector pin length alterationHead chamferingKey flat cutting on the headVent cancellingEjector pin sets cancellingDowel pin（accessory）alterationStandard typeTapped typeCTCSKC　0SKF　0537