K（angle of blanking hole）AN（standard dimension of blanking hole）ANC（designated dimension of blanking hole）AYXh.iii 1P1BLBWP50●Cancel the bottom chamfering.（Standard：X dimension）Range of designation（A/2）＋0.5≦X≦Hー（A/2）ー0.5（Standard：Y dimension）（A/2）＋0.5≦Y≦Vー（A/2）ー0.5（A/2）＋0.5≦X≦（H/2）ー（A/2）ー0.5（Sintered：X dimension）（H/2）＋（A/2）＋0.5≦X≦Hー（A/2）ー0.5（Sintered：X dimension）（Sintered：Y dimension）（A/2）＋0.5≦Y≦Vー（A/2）ー0.50.8≦A≦5（A dimension）NotavailableThe distance between the hole and contour should be 0.5mm or more（refer to right drawings） .Pilot hole depth＝A×5≧5（the hole may be drilled through）Delivery：5 daysh11.5D 6 810●Add a concave to retain straight button dies.Range of designation5≦KM＜LUnit of designation●Alter the blanking hole of angular button dies according to designated dimension.Range of designationAN＜ANC≦P＋4≦Pmax （AN＝P＋（L−B）／TP） Drawing 2 Drawing 3 Drawing 1 Drawing 2P・WseD nottuB&sehcnuP noscerP00 ーMKGeneralFull edge 0.5AvailableSinteredFull edge 0.5AvailableRange not for processingRange not for processingNot availableCode@/PNTC（0）PNC（1,000）●Add a pilot hole for dowel pin.Unit of designation 0.1KM（Steel 400）（Carbide 1,200） 0.1The processing position is opposite to the flat.D≧6 is available.Combined with WKC is not available.ANC（Steel 200）（Carbide 1,200） K（Angle of blanking hole）≦5 （K=tan−1｛（ANC−P）／2（L−B）｝） Drawing 1 B≦（P−0.6）／tanK （round type） B≦（W−0.6）／tanK （special shaped type） Drawing 2 0.1Unit of designationAlter AN to ANC within the range of PCmax by 1/50 taper increment. （ Table 1）Angle（K）of blanking hole is 5°max.The distance between shaped hole length B（C） and wire is 0.6mm minimum. For special shaped hole, entire processing was applied according to the blanking hole angle K calculated from P dimension and ANC dimension. Drawing 1Table 1P0.500〜0.9991.000〜 SRC（1,800）●Add slanted grooves（N）.Range of designation4≦N≦6For round type, P≧4.00 is available.Equidistant slanted grooves are processed on the circle（angle distance＝360°÷N）.For N＝4, refer to left drawing.Bottom chamfering cancellingPilot hole processingRetaining processingBlanking hole dimension alterationSlanted grooves additionANC±0.1120°90°15050Drawing 20.6 or moreShaped holeWireDrawing 3601Add.Spec.TP 50150 Shape Alteration
元のページ ../index.html#603