CLCLLLTχDD4CTTCTCLJCVVHHC 0.122・2.52・2.5・3sehcnuP______L dimension alterationH dimension alterationT dimension alterationEjector pin length alterationV dimension alterationRange of designationχ≦LC＜L Unit of designation Table 10 0.1→Combined with LKC・LKP・LKPZ can be For the overall length LC＜χ, tip length B＝LCーχ1. For quill punches, Shoulder Held Punches and mini punches, refer to the specific page please. Quill punches P.102 Shoulder held punches P.162 Mini punches P.188Ejector punchesRange of designationLC＜L30≦LC＜L（Straight punches・blanks・tapped punch blanks）40≦LC＜L（Other blanks）Unit of designation 0.1→Combined with LKC・LKP・LKPZ can be B is shortened according to （L−LC）,but B≧2.The ejector hole S is shortened according to（L−LC）.The projection length of ejector pin is 2 mm. （for heavy load type:4mm）Range of designationD≦HC＜HUnit of designation 0.1Coating straight punches are not available.Range of designation2≦TC＜T3.5≦TC＜T（Ejector type）4≦TC＜5（Coating straight punches） 0.1→Combined with TKC・TKCM can be Unit of designationL is shortened according to（TーTC）.When LC is applied, L is equal to LC.Shoulder held punchesRange of designation13＜TC＜25Unit of designationFor the overall length L（C）＜50,TC≦20The overall length L dimension is unchanged.Ejector punchesJLC 4〜6Not available 8101316〜2・2.5・3・3.5・4Standard1Combined with JSC（ejector pin material alteration（SUS））is available. For ejector punches with centre hole, D10〜32 are available.Due to the probability of extended projection being broken, pay attention during selection please.Range of designationD4〜6 ： V−0.5≦VC≦D−1.2D8〜 ： V−2 ≦VC≦D−1.2P≦VC 0.1Unit of designationSpecial shaped typeTable10PunchesPunches（round）25＋B（C）Punches（special shaped）30＋B（C）Short punches15＋B（C）Two-step punches（round）Two-step punches（special shaped）Heavy load punches（round）35＋B（C）Heavy load punches（special shaped）40＋B（C）Two-step tapped punchesStraight punchesTapped straight punchesPunch blanksOther blanksStandard25＋F30＋F30＋F2030152083Add.Code@/PLC（200）●Reduce the overall length L dimension. HC（200）●Reduce the head diameter H dimension.P≦HC＜H（Straight punches）TC（200）●Reduce the head thickness T dimension.JLC（200）●Alter the projection length of ejector pin.VC（400）●Alter V dimensionSpec. 0.01. Table 3 0.01. 0.01.Heavy load ejector punchesJLC 8・10Not available13〜204.5・5・5.51.5254.5・5・5.5・6 Dimension AlterationRound type
元のページ ../index.html#85